Briefly Describe The Performance of The Hydraulic Cylinder Components Do Not Work Properly

1, parts of the installation errors, for example, some construction machinery in the device seals in the support ring of the elasticity of the poor, so before installation should be soaked in oil at 100 ℃ for 10 to 20 minutes to make it soft, and then multiply its elasticity is greater when installed.

2, the operation of the components on the problem, this aspect causes more problems in the operation of construction vehicles, new drivers are not familiar with the performance of the machine. For example, there is a construction vehicle half-axle of the spline is often worn, and later found to be the driver to make the differential lock has not been disengaged, resulting in the use of the transmission parts of the load, so that the wear and tear is serious, so to improve the operation.

3, the failure of the relevant parts of the hydraulic cylinder parts caused by damage, for example, an excavator on the two walking hydraulic motor at the same time bad, after checking, is a multi-way rotary joint on the oil seal damage and blocked the circuit caused by, so we must solve this problem in time, otherwise the back of the hydraulic motor will also be damaged.